Gf signet conductivity manual

Monitor C1 Conductivity and C2 Conductivity simultaneously. This is the factory preset view when Channel 2 is ON. Monitor Channel 1 Conductivity and Channel 1 Temperature. This is the factory preset view when Channel 2 is OFF. Monitor Channel 2 Conductivity and Channel 2 Temperature. This view is available only when Channel 2 is ON. • Passive, isolated, fully adjustable and reversible 4 to 20 mA outputs are independently source selectable for conductivity or temperature. • Max loop impedance: 50 Ω . 2 Signet Series Conductivity Sensor Instruction Manual Warning / Caution / Danger Indicates a potential hazard. Failure to follow all warnings may lead to equipment damage, injury, or death Personal Protective Equipment (PPE) Always utilize the most appropriate PPE during installation and service of Signet products. Pressurized System WarningFile Size: KB.

Thank you for purchasing the Signet line of Georg Fischer measurement products. If you would like to register your product(s), you can now register online in one of the following ways: • Visit our website www.doorway.ru Under Service and Support click on Product Registration Form • If this is a pdf manual (digital copy), click here. Conductivity mA-+ Fuse** 1/8A 4 - 20 mA* * CR Terminals Signal IN Temp. IN Iso. Gnd Shld +- Red White Black Silver (Shld) +GF+ SIGNET Sensor: Range (µS): () - 2 Signet Series Conductivity Sensor Instruction Manual Warning / Caution / Danger Indicates a potential hazard. Failure to follow all warnings may lead to equipment damage, injury, or death Personal Protective Equipment (PPE) Always utilize the most appropriate PPE during installation and service of Signet products. Pressurized System Warning.

Remove power to unit before wiring input and output connections. • Follow instructions carefully to avoid personal injury. Signet SIMULATE function allows you to manually set the current loop output to test or calibrate a PLC or chart recorder. Features programmable temperature. () Part 1: Verify Transmitter Settings () Verify Settings () Part 2: Electrode Preparation () Part 3: Temperature.